WET1 1300 Viton Seal Replacement: Confirm Pump Compatibility Before Ordering
07 August 2026
Order a WET1 1300 Viton seal replacement after confirming the pump model, part and service conditions—contact WACME if compatibility is unclear.
The WET1 1300 Seal Viton is a specific replacement component listed by WACME for the WET1 range. It should not be marketed as a universal seal for every high-temperature industrial pump. Before ordering the WET1 1300 Viton seal, confirm the pump model and component required.
What Should Be Checked Before Ordering?
A pump can leak for several reasons, and the visible symptom does not identify the failed component by itself. Record the pump identification and inspect the available parts information. If the equipment has been modified or the model is uncertain, contact our team rather than ordering from a generic description.
Compatibility Information To Provide
The following details help us respond to a parts enquiry:
- Pump model: Identify whether the equipment is a WET1 1300 and provide any model or configuration details shown on the unit.
- Existing part: Confirm the seal being replaced and provide the part number where available.
- Drive arrangement: Note the engine or hydraulic-drive configuration because WET1 pumps are available in different setups.
- Observed problem: Describe leakage, wear or other symptoms without assuming the seal is the only cause.
- Service conditions: Provide the pumped liquid and relevant operating information so compatibility questions can be reviewed.
Viton Grade Selection Is Application-Specific
Viton is a fluoroelastomer brand covering multiple formulations. The manufacturer’s Viton product-selection guidance explains that end-use service, chemical resistance and temperature requirements affect material selection. That general material information does not expand the published application of the WET1 replacement part or prove suitability for an unlisted chemical.
WACME designs and manufactures the WET1 range of tanker water pumps, hose reels, spray equipment and water tankers. Our WET1 1300 product category lists available components. Always confirm current product information and suitability for the specific pump before installation.
Do Not Diagnose The Pump From The Seal Material Alone
A Viton-labelled component does not establish why a pump is leaking. Wear plates, housings, shafts, fasteners, installation condition and operating circumstances may also need inspection. Continued operation after a leak is observed can create additional damage, so isolate the equipment and follow the applicable maintenance procedures before dismantling it.
When contacting WACME, include clear photographs of the pump identification and the removed component where safe to do so. Do not rely on colour or approximate dimensions to identify an elastomer. The product listing and parts information should be used together, and uncertain applications should be referred to our team before purchase.
Check the current listing when ordering because pricing, stock and product information can change. Keep the pump isolated until the repair has been completed and the equipment has been inspected and returned to service under the site’s maintenance procedures.
Request Parts Assistance
Replacing the correct component can help return the pump to service, but installation and fault diagnosis should be performed by suitably competent personnel. Contact us with the pump model, photographs, part details and operating context. We can help identify the listed WET1 component and advise availability.
Optimized by: Netwizard SEO
